Kentrox DataSMART T3/E3 IDSU Installation Manual page 34

34 Chapter 4: Cabling interfaces and ports
Procedure 2
1 Set the baud rate, parity, data and stop bits correctly on the next IDSU, as specified
on page 17.
2
Connect the power cord and power on the unit, as specified on
3
Connect the next IDSU DCE port to the DTE port of the IDSU you just set up.
4
Press the Enter key. This logs you into the next unit and brings up its Main menu.
5 Enter the command DE to disable echo.
6
Enter the command SA:xx:yy:zzz to set the unit's daisy-chain address. The address
must be unique. Do not use address 00:00:000 (this is the default address of all
the units).
xx = 0 - 15
yy = 0 - 15
zzz = 0 - 255
7
Log out (enter <Ctrl-D>).
Repeat procedure 2 for each IDSU you wish to connect to the daisy-chain.
page 22.