Chapter 5 Initial Configuration - Kentrox DataSMART T3/E3 IDSU Installation Manual

C H A P T
5
E R
Initial configuration
This chapter takes you through the minimum configuration steps needed to verify that the
DataSMART T3/E3 IDSU is active and functioning properly. After completing these
steps, your network and data port LEDs should be "yellow" and you can proceed to your
DataSMART T3/E3 IDSU User's Guide for additional configuration or performance
monitoring information.
Topics covered include:
Network configuration
Data port configuration
Verifying the configuration
Procedures for setting up SLIP Telnet or IP access to the DataSMART T3/E3 IDSU are
provided in Chapter 7 of your user's guide.
(page 39)
(page 40)
(page 41)
37