Engine Cradle Crossmember - Chrysler 2000 LHS Owner's Manual

LH
REMOVAL AND INSTALLATION

ENGINE CRADLE CROSSMEMBER. . . . . . . . . . . . 7

REAR SUSPENSION CROSSMEMBER . . . . . . . . . 8
DISASSEMBLY AND ASSEMBLY
REAR SUSPENSION CROSSMEMBER
BUSHINGS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
REMOVAL AND INSTALLATION
ENGINE CRADLE CROSSMEMBER
REMOVAL
CAUTION: VERIFY THAT VEHICLE IS PROPERLY
SUPPORTED AND SECURED TO THE LIFTING
DEVICE. VEHICLE CENTER OF GRAVITY WILL
CHANGE WHEN HEAVY
REMOVED CAUSING A HAZARDOUS CONDITION.
(1) Release hood latch and open hood.
(2) Remove nuts holding engine mounts to cradle.
(3) Install a suitable engine support device.
(4) Raise and support vehicle on safety stands.
(5) Remove bolts holding transaxle crossmember to
cradle.
(6) Lower vehicle and lift engine and transaxle off
cradle.
(7) Raise and support vehicle on safety stands.
(8) Disconnect sway bar links.
(9) Remove bolts retaining suspension lower ball
joints to spindles.
(10) Separate lower control arm from spindle.
Refer to Group 2, Suspension, for proper procedures.
(11) Support cradle on a 10 cm by 10 cm by 90 cm
(4 in. by 4 in. by 36 in.) wood beam and a jack.
(12) Remove bolts holding cradle to body shell
(Fig. 1).
(13) Lower cradle away from body shell.
INSTALLATION
NOTE: If cradle replacement is required, transfer
suspension components and jounce and bounce
plates to replacement cradle.
(1) Support cradle on wood beam and a jack.
(2) Position cradle under body shell.
(3) Install bolts to hold cradle to body shell.
(4) Connect lower control arms to spindles. Refer
to Group 2, Suspension, for proper procedures.
FRAME
TABLE OF CONTENTS
page
COMPONENTS ARE
FRAMES AND BUMPERS
SPECIFICATIONS
FRAME DIMENSIONS . . . . . . . . . . . . . . . . . . . . . 11
TORQUE SPECIFICATIONS . . . . . . . . . . . . . . . . . 15
Fig. 1 Engine Cradle
1 – FRONT FRAME RAILS
2 – TRANSAXLE CROSSMEMBER
3 – CROSSMEMBER BOLTS
4 – CROSSMEMBER BOLTS
5 – CRADLE MOUNT BOLTS
6 – ENGINE CRADLE
7 – ENGINE MOUNT BOLTS
(5) Install bolts to retain suspension lower ball
joints to spindles.
(6) Connect sway bar links.
(7) Lower vehicle and lower engine and transaxle
onto cradle.
(8) Raise vehicle.
(9) Install bolts to hold transaxle crossmember to
cradle.
(10) Lower vehicle.
(11) Remove engine support device.
13 - 7
page