Sunroof Wind Deflector; Sunroof Housing Assembly; Sunroof Drive Motor And Express Module; Wind Deflector - Chrysler 2000 LHS Owner's Manual

LH
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Ensure that the glass panel is in the fully
closed position before mounting the motor. If motor
fails with the window in the open position the sun-
roof glass panel timing will have to be timed. The
new motor comes in the fully closed position and
with a gage for setting cable timing. Refer to Sunroof
Glass Panel Timing.
(2) Place drive motor into position on the sunroof
housing and install fasteners.
(3) Set headliner into position.
(4) Connect express module, drive motor, and con-
trol switch wire connectors.
(5) Test sunroof operation, adjust as necessary.
(6) Finish installing the headliner.
(7) Connect the control switch wire connector.
(8) Install A-pillar trim, sun visors, and map
lamps/mini console.
Fig. 3 Sunroof Drive Motor and Express Module
1 – EXPRESS MODULE
2 – SCREW

SUNROOF WIND DEFLECTOR

REMOVAL
(1) Open sunroof glass panel.
(2) Push down one corner of the wind deflector and
let the other corner rise up (Fig. 4).
(3) Push the low corner towards the opposite side
of the vehicle until tab on sunshade clears the body.
Then raise the corner up.
(4) Repeat the procedure to the other corner.
(5) Lift wind deflector to 90% of the way.
(6) Push the attaching ends of the deflector to the
rear of the vehicle to disengage the deflector.
INSTALLATION
(1) Place wind deflector at 90% in the vertical posi-
tion to the sunroof. With the sunroof open.
(2) Push ends of the deflector towards the front of
the vehicle to engage ends.
(3) Lower wind deflector to normal position.
(4) Push one corner to the opposite side of the
vehicle until tab clears vehicle body and lower deflec-
tor for that corner.
(5) Push the side that was just installed com-
pletely down.
(6) Push the opposite corner cross vehicle until tab
clears the body. Then lower deflector to position.
(7) Test sunroof operation.
Fig. 4 Wind Deflector
1 – WIND DEFLECTOR
2 – TAB

SUNROOF HOUSING ASSEMBLY

REMOVAL
(1) Move glass panel to the fully closed position.
(2) Remove instrument panel end caps right and
left side.
(3) Remove right and left A-post trim panels.
(4) Remove right and left sun visors, and sun
visors retainers.
(5) Remove over head console let hang from head-
liner.
(6) Remove front passenger grab handle.
(7) Remove right and left upper B-post trim pan-
els.
(8) Remove rear right and left grab handle/lamps
and let hang from headliner.
(9) Remove right and left C-post trim panels par-
tially.
(10) Recline both front seats.
(11) Disconnect battery negative cable.
(12) Disconnect wire harness connector along
A-post to fuse panel.
(13) Disconnect mirror wiring connector.
(14) Disconnect sunroof harness connector at the
C-post.
(15) Disengage headliner rear locating clip.
(16) Remove headliner through the rear door.
BODY 23 - 25