Fault Diagnosis; Malfunctions; Drying Programme Does Not Start; Drying Programme Only Briefly Starts Running - Siemens WT46W430FF Manual

Fault diagnosis

4.1

Malfunctions

Fault

Drying programme does not start

Drying programme only briefly starts
running

Drum not rotating

Driving system

Drum does not turn
2015-09-07 / DIS 113_58300000171499_ara_en_c
Possible cause
Power supply not connected
Childproof lock is activated
Ambient temperature < 5 °C
Fatal error
Door switch function
Electrical connections slack/loose
Load too dry (empty drum detected)
Underloading
Error in conductivity system
Moisture sensors coated
Door shutting function (brief opening)
Fan wheel scraping on process air duct
Switching contact does not switch
Cable break
Motor not rotating
Copyright by BSH Hausgeräte GmbH
Troubleshooting
► Check power supply
► Check fuse in the fuse box
► Check plug-and-socket connections
► Check power cord for damage
► Customer advice see operating instructions
► Installing the appliance (Page 34)
► Customer advice see operating instructions
► See circuit diagrams
► See circuit diagrams
► Check that electrical connection is fitted correctly.
► Replacing electrical connection
► Select additional timer programme
- Overdose or insufficient dose of detergent can lead to this error image.
- Fabric softener alters the surface of fibres. The electronics receive false values and
switch off.
► Cleaning, see instruction manual
► Customer advice
? Repair set [ 11003634]
► Install repair set. (Page 56)
► Replace door switch
► Replace cable
► Run motor test programme.
► Check motor capacitor / Replace
► Replacing the motor
Page 25 of 65