Replacing Motor - Siemens WT46W430FF Manual

Repairs
6.17

Replacing motor

Graphic 22:Motor
2015-09-07 / DIS 113_58300000171499_ara_en_c
1 Electrical connection
2 Motor shaft
3 Tension spring
Prerequisite:
• Worktop has been removed.
• Right side panel has been removed.
• Drive belt has been removed.
6.17.1 Removing motor
1. Remove electrical connections from the motor (1) and protect against damage.
2. Remove module housing cover (process air).
3. Remove process air duct.
4. Secure motor shaft (2) using a wrench.
5. Turn fan roller (process air) to the left and remove.
6. Detach tension spring (3).
7. Remove screws.
8. Take motor out of the appliance.
6.17.2 Installing motor
.
2. Install motor in reverse sequence.
Copyright by BSH Hausgeräte GmbH
4 Wheel
5 Motor support
Ensure that the drive belt is fitted correctly! Always observe the
gap between the pulleys.
Page 57 of 65