Command Line Interface Management Using Ssh; Web Interface Management; Snmp Management; Setting Up Command Line Interface Management - 3Com SuperStack 3 4400 SE 3C17206 Getting Started Manual

50 C 3: S
HAPTER ETTING
Command Line
Interface
Management using
SSH
Web Interface
Management

SNMP Management

Setting Up
Command Line
Interface
Management
U M
P FOR ANAGEMENT
The Switch 4400 supports Secure Shell version 2 (SSHv2), allowing secure
access to the Command Line Interface of the Switch.
If you use SSH to administer your Switch and the network traffic is
intercepted, no passwords or configuration information will be visible in
the data. To securely adminster the Switch using the Command Line
Interface you need a third party SSH client.
Each Switch has an internal set of web pages that allow you to manage
the Switch using a Web browser remotely over an IP network (see
Figure 18).
Figure 18 Web interface management over the network
Refer to "Setting Up Web Interface Management" on page 53.
You can manage a Switch using any network management workstation
running the Simple Network Management Protocol (SNMP) as shown in
Figure 19. For example, you can use the 3Com Network Supervisor
software that is provided on the CD-ROM that accompanies your Switch.
Figure 19 SNMP management over the network
Refer to "Setting Up SNMP Management" on page 54.
This section describes how you can set up command line interface
management using a local console port connection or over the network.