Setting Up Overview - 3Com SuperStack 3 4400 SE 3C17206 Getting Started Manual

36 C 3: S
HAPTER ETTING
Setting Up
Overview
U M
P FOR ANAGEMENT
This section gives an overview of what you need to do to get your Switch
set up and ready for management when it is in its default state. The
whole setup process is summarized in Figure 9. Detailed procedural steps
are contained in the sections that follow. In brief, you need to:
Configure IP information manually for your Switch or view the
■
automatically configured IP information
Prepare for your chosen method of management
■
Figure 9 Initial Switch Setup and Management Flow diagram
How do you want to connect to the Switch?
Connect to a front
panel port and use the
Web Interface or
Command Line Interface.
See page 39
Command Line Interface
Connect via the
console port.
See page 51
Power Up the Switch.
IP Information is automatically configured.
See page 37
Do you want to manually
Yes
configure the IP information?
Connect to the console
port and use the
Command Line
Interface.
See page 39
How do you want to manage your Switch? See page 49
SNMP
See page 54
Connect over the
network via Telnet.
See page 51
No
How do you want to view the automatically
configured IP information?
Use 3Com Network Connect to the console
Supervisor (3NS). port and use the
See page 46 Command Line
Interface.
See page 46
Web Interface
Connect over the
network.
See page 54