Using Power Over Ethernet - 3Com SuperStack 3 4400 SE 3C17206 Getting Started Manual

Using Power over
Ethernet
CAUTION The Switch has no ON/OFF switch; the only method of
connecting or disconnecting mains power is by connecting or
disconnecting the power cord.
CAUTION: The Switch can only use a SuperStack Advanced Redundant
Power System output.
The Switch 4400 PWR can power any IEEE 802.3af compliant device
through any of its front panel ports. The Switch will support the following
3Com 802.3af equipment:
Wireless:
■
3Com 11 Mbps Wireless LAN Access Point 8000 (3CRWE80096B)
■
3Com 11 Mbps Wireless LAN Access Point 8200 (3CRWE820096A)
■
3Com 11 Mbps Wireless LAN Access Point 8500 (3CRWE850096A)
■
3Com 11 Mbps Wireless LAN Access Point 8700 (3CRWE870096A)
■
3Com Wireless LAN Building to Building Bridge (3CRWE91096B)
■
Voice Over IP Telephones:
■
3Com 11 Mbps Wireless LAN Access Point 8000 (3CRWE80096B)
■
3Com 11 Mbps Wireless LAN Access Point 8200 (3CRWE820096A)
■
3Com 11 Mbps Wireless LAN Access Point 8500 (3CRWE850096A)
■
3Com 11 Mbps Wireless LAN Access Point 8700 (3CRWE870096A)
■
3Com Wireless LAN Building to Building Bridge (3CRWE91096B)
■
The following 3Com NBX phones are also supported using the 3Com
■
NBX VoIP Phone Module (3CNJVOIPMOD-NBX):
3Com NBX 1102 Business Phone (3C10121)
■
3Com NBX 1102B Business Phone (3C10281B)
■
3Com NBX 1102PE Business Phone (3C10281PE)
■
3Com NBX 2101Basic Phone (3C10248B)
■
3Com NBX 2101PE Basic Phone (3C10248PE)
■
3Com NBX 2102 Business Phone (3C10226A)
■
3Com NBX 2102IR Business Phone with IR (3C10228IRA)
■
3Com NBX 2102B Business Phone (3C10226B)
■
3Com NBX 2102IRB Business Phone with IR (3C10228IRB)
■
The Power-up Sequence 31