Setting Up Command Line Interface Management Using Ssh; Setting Up Web Interface Management - 3Com 4210 Getting Started

48 C 3: M
HAPTER ANAGING YOUR
Setting Up Command
Line Interface
Management using
SSH
Setting Up Web
Interface
Management
Prerequisites
S
WITCH
If the login prompt does not display immediately, press Return a few times until it
starts.
6 If you have logged on correctly, the switch you want to manage is displayed as
<4210>, as shown in on page 44.
To set up command line interface management using SSH, refer to the chapter
entitled "SSH Configuration" in the "3Com Switch 4210 Family Configuration
Guide."
This section describes how you can set up web interface management over the
network.
Ensure that you have already set up the switch with IP information as described
■
in "Methods of Managing a Switch" on page 36.
Ensure that the switch is connected to the network using a Category 5 twisted
■
pair Ethernet cable with RJ-45 connectors.
A suitable Web browser.
■
Choosing a Browser
To display the web interface correctly, use one of the following Web browser and
platform combinations:
Table 17 Supported Web Browsers and Platforms
Windows
Browser 2000
Netscape 7.1 Yes
Internet Explorer 5.5 Yes
Internet Explorer 6.0 Yes
Mozilla 1.4 No
For the browser to operate the web interface correctly, JavaScript™ and Cascading
Style Sheets must be enabled on your browser. These features are enabled on a
browser by default. You will only need to enable them if you have changed your
browser settings.
Platform
Windows Windows
XP Server 2003
Yes No
Yes Yes
Yes Yes
No No
Red Hat Solaris
Linux 9 7/9
No Yes
No No
No No
Yes Yes