Placing Units On Top Of Each Other; Stacking Units; How To Stack Units - 3Com SuperStack 3 4400 SE 3C17206 Getting Started Manual

Placing Units On
Top of Each Other

Stacking Units

How To Stack Units

If the Switch units are free-standing, up to eight units can be placed one
on top of the other. If you are mixing a variety of SuperStack
and Hub units, the smaller units must be positioned at the top.
If you are placing Switch units one on top of the other, you must use the
self-adhesive rubber pads supplied. Apply the pads to the underside of
each Switch, sticking one in the marked area at each corner. Place the
Switch units on top of each other, ensuring that the pads of the upper
unit line up with the recesses of the lower unit.
Switch 4400 units can be stacked together and then treated as a single
manageable unit with one IP address. Any combination of 24-port and
48-port units is allowed in a single stack.
The SuperStack 3 Switch 4400 SE can only be stacked with non-SE
Switches if it has been upgraded using the Switch 4400 SE Enhanced
Software Upgrade (3C17207). An upgraded Switch 4400 SE cannot be
stacked with a normal Switch 4400 SE.
To stack two Switch 4400 units you will need to order the SuperStack 3
Switch Cascade Stacking Kit (3C17227). The kit consists of two Cascade
Modules and a Cascade Cable. Both Switches must have an unused
expansion slot to allow a Cascade Module to be fitted.
Figure 7 Stacking two Switch 4400 units
To stack more than two Switch units you will need to order one
SuperStack 3 Cascade Extender Kit (3C17228) for each additional unit.
This Kit consists of one Cascade Module, one Cascade Cable and one

Placing Units On Top of Each Other

M o
d u le
2
3 C 1
7 2 2
4
S u p
e rS ta
ck 3
C a sc
a d e
M o d
u le
M o
d u le
2
3 C 1
7 2 2
4
S u p
e rS ta
ck 3
C a sc
a d e
M o d
u le
27
® 3 Switch
Switch 2
Switch 1