Table of Contents
Advertisement
pictor M1606
Operation
8.2.3 Connect to the operation software
Connect the device with the operation software vcwin pro via:
• Menu: Communication > Connect
or
•
Toolbar
The initialisation of the host computer interface sets up a connection with the
device via vcwin pro. The Run Mode is interrupted and the system resources
are queried. vcwin pro uses the initialisation to recognise all the geometry
variables, results, contour buffer, counters, image memory pages and I/O
hardware available from the device connected. After initialising, the system is in
Command Mode and vcwin commands may be used.
© Vision & Control GmbH 2014
999.994.256.10-en-1.4
48
Advertisement
Table of Contents
