Trigger Interface - Vision & Control Pictor M1606 Instructions For Use Manual

pictor M1606
Product Data

5.1.4 Trigger interface

The device has a special trigger interface, a dedicated fast TTL trigger input
(for use as image capture trigger) and a fast TTL trigger output (Strobe
Trigger).
Both signals are very fast and have a very low signal to noise ratio, it is
recommended to keep the cable as short as possible. Use only shielded cables
for this purpose.
Parameters Trigger interface
Parameter
Quantity
Output voltage
Output current
Switching level
Input voltage Low
Input voltage High
Output voltage Low
Output voltage High
Neither the trigger input is nor the trigger output has an in-built in photo
coupler.
Ensure that the electrical specifications of this section are met and provide
galvanic isolation to trigger input and output if necessary.
© Vision & Control GmbH 2014
Min
0 V DC
2 V DC
0 V DC
2.4 VDC
ADVICE
999.994.256.10-en-1.4
Nom Max
1
7 V DC
50 mA
0.8 V DC
5 V DC
0.4 V DC
5 V DC
26