Panel And Trim Set - Quadra-Fire SANTAFEI-MBK Installation Manual

G. Panel and Trim Set
1. Lay panel top and legs face down on protective covering
to prevent scratching.
1. Attach the panel legs to the top panel using a Phillips
head screwdriver. There are 2 screws for each leg.
Figure 21.2.
2. Open the hopper lid by pulling toward you. This will make
it easier to set the panels in place. Secure the panels to
the insert, 2 screws per leg, as shown in Figure 21.3.
3. Connect the trim pieces together using the "L" Brackets
supplied. Figure 21.4.
4. Slide the trim over the top of the panels.
5. Install the access panels. At the bottom of the access
panel there are 2 hooks that slip into a slot at the bottom
of the side panel and a magnet at the top that holds the
access panel in place. Figure 21.3.
Figure 21.1- Completed View
Attach panel
legs to top
Figure 21.2
June 5, 2017
Open Hopper Lid for
Easier Placement of
Panel Set
Access Panels
Figure 21.3
Figure 21.4
7019-230G
Santa Fe Pellet Insert
Magnet
Side
Panel
Hook
Access Panel
21