Cleaning And Care - RAIS Q-Tee Wall User Manual

Hide thumbs Also See for Q-Tee Wall:
Table of Contents

Advertisement

English
RAIS - Manual for RAIS Q-Tee

Cleaning and care

Glass
Most woodstoves use a ceramic glass product which is resistant to heat but requires
cleaning to keep its appearance.
Soot or opaque marks can easily cleaned if the marks are fresh, however If you leave
the glass dirty for any length of time the acid from the wood can etch the surface of
the glass permantley (wet unseasoned wood, soft wood such as used in the building
industry, pallet wood should be avoided).
Only clean when cold.
Use only stove glass cleaners to re-move heavy tar/ soot deposits.
All other marks can normally be removed with a damp cloth, then dry with a clean
cloth or newspaper, do not let the glass dry before applying a dry clean cloth.
With more stubborn marks i.e. Opaque areas / frosting, you need put a small amount
of wood ash on a clean damp cloth. If the opaque mark /frosting, doesn't come out,
contact your dealer for a special remover.
Paint finish
The appliance has been coated with a high temperature paint which can last for years.
Do not clean with a damp cloth or any cleaning products as they can cause rust or
discolouration. Only clean when cold use a brush with soft bristles or dust with a lint
free cloth
Only re-spray when necessary.
The wood burning stove and the chimney must be serviced by a chimney sweep twice a
year. During cleaning and care, the stove must be cold.
Cleaning the combustion chamber:
Scrape/shovel the ash out and store it in a non-flammable container until it has cooled
down. You can dispose of ash with your normal household waste.
REMEMBER!!
Never remove all the ashes from the combustion chamber - the wood
will burn at its best with a layer of ashes of approx. 20 mm.
Prolonged period of non-use:
If the stove is to be left unused for a prolonged period of time then it should be given a
thorough clean to remove ash and unburned fuel residues. To enable a good flow of air
through the appliance to reduce condensation and subsequent damage, leave the air
controls fully open.
Prior to a new heating season, it should be checked that the chimney and smoke gas
connector are not blocked.
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q-tee insert

Table of Contents