Bluetooth Operation - Jensen SMPS-750 User Manual

Bluetooth all-in-one hi-fi music system with pa

Hide thumbs Also See for SMPS-750:

User manual (11 pages)

Table Of Contents

Table of Contents

TIPS FOR BEST RECEPTION

FM - During FM reception, always keep the FM Wire Antenna fully extended and

hanging high up on the wall. If reception is weak, try repositioning the FM Wire Antenna

until you find the strongest signal.

Pairing a Bluetooth enabled device with the SMPS-750.

1. Turn on the SMPS-750.

2. Tap the MODE BUTTON (#12) repeatedly to select Bluetooth mode. "bt" will appear on

the LED DISPLAY (#16) and flash. You will hear four (4) "beeps" confirming you are in

pairing mode.

3. Turn on the Bluetooth function of the device you want to link to and enable the search

or scan function to find the SMPS-750.

4. Select "SMPS-750" from the device list when it appears on your device screen. If

required, enter the pass code "0000" to pair (link) SMPS-750 with your device.

5. If you are pairing (linking) your computer to the speaker using Bluetooth, you may need

to set the SMPS-750 as your computer's default sound device.

6. After successfully pairing the SMPS-750 with your Bluetooth device. You will hear two

(2) "beeps" confirming that the device is connected.

7. If you want to pair (link) the SMPS-750 with another Bluetooth device, disconnect the

connection by using the connected BT device. You will hear a disconnect tone which are

three (3) "beeps". Repeat steps 3 & 4. You will hear a confirmation tone to confirm that

the new pairing is successful.

Now you can play music from your Bluetooth device wirelessly to the SMPS-750.

1. Select your favorite song, press

PLAY/PAUSE

Bluetooth device.

2. Tap the

BUTTON (#12) or

3. Slowly adjust both the volume control of your SMPS-750 and your Bluetooth device until

you reach a comfortable listening level.

Notes:

Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth

enabled devices for Bluetooth operation since it may vary from model to model.

If your Bluetooth enabled device does not support A2DP profile, it will not play the

music through the speaker, even if paired (linked).

Remember to turn off the SMPS-750 when you have finished listening.

•

Don't forget to switch off the power of your Bluetooth device as well.

The repeat function does not apply to the Bluetooth operation.

•