Welding Power Source Setup Menu - Miller XMS 403 Owner's Manual

4-3. Welding Power Source Setup Menu

P1 - Welding Parameter Setup But-
ton.
P2 - Power Source Setup Button.
Press and hold P1 and P2.
XMS 403 appears on D1 and D2 fol-
lowed by UNIT - IPM.
Wire feed speed is displayed as
P1
P2
(IPM) inches per minute.
Rotating knob P2 scrolls through
the following options:
UNIT MPM - Wire feed speed is
displayed in Meters Per Minute.
UNIT CUR - Power source will dis-
play welding current.
UNIT THCK - Power source weld-
ing parameters will be chosen ac-
cording to the gauge (thickness) of
material to be welded.
Rotating knob P1 scrolls through
the following options:
W-UN AUTO - Rotate P2 to select
water cooling unit mode. AUTO
(Default) ON (Continuous) or OFF
(Water cooling not required)
RCTY 1 - Selects function mode for
remote receptacle (TIG).
Rotating P2 selects the following:
RCTY 2 - Selects function mode for
remote receptacle (For future ap-
plications)
RCTY 3 - Selects function mode for
remote receptacle (For future ap-
plications)
RCTY 4 - Selects function mode for
remote receptacle (For future ap-
plications)
LANG ENG - Selects language
ENG = English (Default)
Rotating P2 selects the following:
LANG FRA - Selects language
FRA = French
LANG ITA - Selects language ITA
= Italian
LANG GER - Selects language
GER = German
LANG SPA - Selects language
SPA = Spanish
Ref. 956142645-5-5
OM-244 243 Page 18