Section 4 − Specifications; Serial Number And Rating Label Location; Software Licensing Agreement; Information About Default Weld Parameters And Settings - Miller Syncrowave 400 Owner's Manual

Table of Contents

4-1. Serial Number And Rating Label Location

The serial number and rating information for the power source is located on the rear of the machine. Use the rating labels to determine input power

requirements and/or rated output. For future reference, write serial number in space provided on back cover of this manual.

4-2. Software Licensing Agreement

The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at

https://www.millerwelds.com/eula

4-3. Information About Default Weld Parameters And Settings

NOTICE − Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical welding

parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are for reference

purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriateness of all parameters

and settings should be evaluated and modified by the end user as necessary based upon application-specific requirements. The end user is solely

responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld parameters and settings, and ultimate

quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warranties including any implied warranty of fitness

for a particular purpose.