Assembly; Bench Stand; Attaching The Zoom Assembly & Objective; Attaching The Head & Control Box - Vision Engineering Ergo 80 User Manual

ASSEMBLY

Bench stand

Attaching the zoom assembly & objective
Ensuring all components are clean and dust-free, proceed as follows:
X Loosen the securing screw
X Lower the zoom assembly
X Tighten the securing screw.
X Screw the objective lens
Attaching the head & control box
X Place the adapter ring u
and using a 2mm Allen key, secure it with the securing
grub screw w .
X Place the head x on to the adapter ring and secure it by
tightening the securing screw
Note: The ISIS ergonomic eyepieces are illustrated
but the procedure for the Standard eyepieces
is the same.
X Remove the 2 securing screws
and lift the cap off.
X Place the control box |
top cap and secure it in place with the replacement screws.
www.visioneng.com/support
u .
v into the stand's head location ring
x up into the zoom assembly.
on to the zoom assembly
y .
z from the top cap
on top of the stand, replace the
w .
w
u
x
v
u
y
w
{
v
ASSEMBLY
v
z
x
{
|
Ergo 80 stereo microscope
3