Moving parts can pinch, crush or cut. Keep clear and use caution. NOTe: Lippert Components, Inc. recommends that the following inspections, troubleshooting, component replacement, and verifications be completed only by certified RV technicians. Page 2 Rev: 02.03.2017...
" away from the outside wall of the bed slide to ensure there is enough space for the bed tilt to fully operate (Fig. 3). Fig. 1 Solid Surface Fig. 2 Fig. 3 Mount " away from outside wall Page 3 Rev: 02.03.2017 Schwintek Bed Tilt Install Manual...
Fig. 6 Fig. 5 " Gap Place the mattress on top of the plywood once it is secure (Fig. 7). Place strap over the mattress to secure it in place. Fig. 7 Page 4 Rev: 02.03.2017 Schwintek Bed Tilt Install Manual...
NOTe: To reset the stops, press and hold the configuration button for five seconds. This will allow the system to enter calibration mode. Fig. 8 - Controller Fig. 9 - Switch Down (A) Red LeD (C) Motor Connector Port Up (B) Green LeD (B) Configuration Button (A) Page 5 Rev: 02.03.2017 Schwintek Bed Tilt Install Manual...
When an error code is present, the board needs to be reset. Energizing the extend/retract switch resets the board. Energize the extend/retract switch again for normal operation. Page 6 Rev: 02.03.2017 Schwintek Bed Tilt Install Manual...
Page 8
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Schwintek and is the answer not in the manual?
Questions and answers