NORMA 4000/5000
Operators Manual
Set View Mode
You have the option to view individual measured values or a group of up to three values
(that is, all measured values of a channel) in graphic or table format. By default, the
measured values are shown in graphic format.
Harmonic Order Mode
View Harmonics
1. Press function key mode to switch directly to mode DFT and call up a table showing
2. Alternatively, use function key Config to select mode DFT in the harmonics setup
8-24
Shop for Power Metering products online at:
1. Press function key → table.
The data is now shown in a table in numerical format (shown here, current on
channel 1).
the integer harmonics.
Switching between FFT and DFT is even possible in HOLD mode and
therefore allows different views on the data from the same single interval.
screen. Afterwards, press Esc to return to the measurement screen.
Modes FFT and DFT share the same frequency range setting.
www.
Note
Note
PowerMeterStore
esn107.eps
1.877.766.5412
.com