Adjust Date And Time; Configure Current And Voltage Channels - Fluke NORMA 4000 Operator's Manual

Adjust Date and Time

Adjust date and time with these steps:
The menu field Clock Setup shows the time in hours, minutes and seconds.

Configure Current and Voltage Channels

Prior to each measurement, you must configure the device inputs (channels). The
following example explains the configuration procedure for current channel I1: The other
current and voltage channels can be configured in the same way.
Shop for Power Metering products online at:
The synchronization output is connected at the Sync-BNC plug on the
backside of the unit. The output signal is a TTL pulse with 5 Volt.
The BNC can be used either as input or output. As soon as the BNC plug is
switched to input (EXT sync source or OFF selected), the sync output menu
is automatically switched to OFF (disabled).
Normally, date and time must be set only once, as they do not change with
different configurations.
1. Move the cursor to menu item Clock Setup and press Enter.
The Clock Setup menu is displayed. The value in column Year is highlighted.
2. Press Enter, select a year and confirm with Enter.
The selected year is displayed.
3. Move the cursor to the next field and repeat the above step until the correct date
and time are shown.
www.
Note
Note
Note
PowerMeterStore
Configuration

Adjust Date and Time

esn022.gif
7-13
1.877.766.5412
.com
7