Risks During Operation; Maintenance And Repairs; Accessories; Shutting Down - Fluke NORMA 4000 Operator's Manual

Risks During Operation

Maintenance and Repairs

Accessories

Shutting Down

Safety Instructions on the Device Housing

Mains Connection

MAINS 85 - 264 V / 47 – 440Hz / 120 – 300 V
Mains connection must conform to these ranges/values
40 VA (NORMA 4000) and 65 VA (NORMA 5000)
Maximum power consumption

Input Voltage and Current

Shop for Power Metering products online at:
•
Ensure that the connected devices work properly.
•
In the case of a direct connection to current circuits (without transformer or
shunt), ensure that the circuit is protected to maximum 16 A.
•
Shunts and conductors generate heat when in use and surfaces may burn the skin.
•
Do not open the housing. Do not carry out any repairs and do not replace any
component parts of the device.
•
Damaged connecting and power leads must be repaired or replaced by an
authorized service technician.
•
Damaged or defective devices may only be repaired by authorized technicians.
•
Only use the accessories supplied with the device or specifically available as
optional equipment for your model.
•
Ensure that any third-party accessories used in conjunction with the device
conform to the IEC 61010-031/61010-2-032 standard and are suitable for the
respective measuring voltage range.
•
If you detect any damage to the housing, controls, power cable, connecting leads,
or connected devices, immediately disconnect the unit from the power supply.
•
If you are in doubt as regards the safe operation of the device, immediately shut
down the unit and the respective accessories, secure them against inadvertent
switching on, and bring them to an authorized service agent.
To avoid possible electric shock or personal injury:
VOLTAGE INPUTS MAX 1000 V CAT II to .
CURRENT INPUTS MAX 1000 V CAT II to .
If the measuring circuit is used to measure MAINS, the voltage
to earth . may not exceed 1000 V in a CAT II Overvoltage
Category environment.
www.

XW Warning
PowerMeterStore
General Safety Instructions

Risks During Operation

1.877.766.5412
.com
2
2-5