Emerson ROCKPOINTE CF630ORB00 Owner's Manual page 7

3. Ceiling Fan Assembly
3.7
Place the Ceiling Cover over the 4.5" Downrod and rest
it on the Coupler Cover (Figure 6).
Be sure both the Ceiling Cover and the Coupler Cover
are oriented correctly as in Figure 6.
3.8
NOTE: Only use the hanger ball supplied with this
ceiling fan.
Route the three 80" Motor Wires through the Hanger
Ball.
Reinstall the Hanger Ball (Figure 7) on the Downrod as
follows:
Position the Hanger Ball Pin through the two holes in
the Downrod and align the Ball so the Pin is captured in
the groove in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball.
NOTE: A loose set screw could create fan wobble.
3.9
The fan comes with Black, Blue and White Wires that
are 80-inches long.
Before installing the fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 8).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
(Continued)
4.5" DOWNROD
CEILING
COVER
COUPLER
COVER
Figure 6
PIN
Figure 7
HANGER BALL/
DOWNROD
ASSEMBLY
Figure 8
Please contact 1-800-654-3545 for further assistance
7
4.5" DOWNROD
HANGER BALL
SET SCREW
6 to 9
INCHES
emersonfans.com
ETL Model No.: CF630