Radio Thermostat CT102 User Manual page 55

Product Name: CT102
Document Title: CT102_ZW_IB_12feb15.ai
Document Type Code: IB
Part Number: 1503-007
15feb15 initial release mtf
How to join a
Z-Wave Network
®
The CT102 is a Z-Wave compliant thermostat. It has an onboard radio that can be mated with
®
an existing Z-Wave network. To connect to a network follow these steps:
®
1) Set your primary controller to INCLUDE mode to add the thermostat as a node on your
network (see your specific controller's User Manual for detailed instructions).
2) Touch the main temperature display to bring up the
manual screen. Touch the MENU icon. Touch the
MATE button on the MENU screen. A large r1 will be
displayed.
3) This will bring you to the network joining screen.
Confirm by touching MATE again. This will initiate the
mating process. The MATE icon and the status indicator
LEDs will blink.
4) When a device has joined a network the LINK icon
will appear under the radio tower. Similarly, when you
are trying to leave a network, the icon LINK will disap-
pear when the node has successfully left the network.
5) Your controller will indicate the thermostat was
successfully added to its network (see your specific
controller's User Manual for details.)
1503-007
FRONT
FCC and IC Statement
FCC Regulatory Information:
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
a) reorient or relocate the receiving antenna,
b) increase the separation between the equipment and receiver,
c) connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
IC Regulatory Information:
This Class B digital apparatus meets all requirements of the Canadian Interference Causing
Equipment Regulations. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation of the device. Cet
appareillage numérique de la classe B répond a toutes les exigences de l'interférence
canadienne causant des règlements d'équipement. L'opération est sujette aux deux condi-
tions suivantes: (1) ce dispositif peut ne pas causer l'interférence nocive, et (2) ce dispositif
doit accepter n'importe quelle interférence reçue, y compris l'interférence qui peut causer
l'opération peu désirée.
WARNING: Changes or modifications to this receiver not expressly approved by RTCOA void
the user's authority to operate this equipment.
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.