Radio Thermostat CT102 User Manual page 16

Test Installation
If you have a heat pump, leave the CT102 in Off mode for 4
minutes before checking Cool.
Do not operate AC if the outside temp is below 65°F.
To Check Fan (If you connected the G wire)
1. Touch the fan icon on the HOME screen to turn the fan ON.
2. Verify that air is blowing from the system. Touch the fan icon again
to return to AUTO.
To Check Heat
1. Touch the temperature display to open the Manual screen.
2. Use the  or  arrows to set the mode to Heat.
3. From the Manual screen, touch the Temperature Up arrow until
the target temperature is 5º above room temperature. Allow the
system two (2) minutes to respond.
4. Verify that heat is blowing from the system. Return the target
temperature to a normal setting.
5. From the Manual screen, set the mode to Off.
To Check Cool
1. Touch the temperature display to open the Manual screen.
2. Use the  or  arrows to set the mode to Cool.
3. Touch the Temperature Down arrow icon until the target temp is
5º below room temperature. Allow the system five (5) minutes to
respond.
4. Verify that cool air is blowing from the system. Return the target
temperature to a normal setting.
5. From the Manual screen, set the mode to Off.
16
Installation Guide CT102
Setup