Evacuation System; Air Principle - Electrolux T5130 Installation Manual

14
Demount the locking panels by loosening the barb with a screwdriver.
Press out the locking panels, swap them over and press into position.
Mount the door on the other side. Push the door and the top pivot into the upper hinge and then adjust the lower pivot
into the lower hinge. Mount the remaining screw when the lower pivot is in correct position. Tighten the screws.
Connect the power to the machine.
Test run the machine.

6 Evacuation system

6.1 Air principle

T5130
The fan creates low pressure in the machine, drawing air into the drum via the heating unit.
The heated air passes through the garments and the drum vents.
The air then flows out through a lint filter positioned in the door. After this, the air is evacuated through the fan and ex-
haust system.
Note!
It is very important that the machine gets enough fresh air in order to get the best drying result.
T5130C
The condensate machine does not have evacuation of air into the open.
The air is circulated in a closed system between the machine and the condensing unit. The water in the garments
condenses in the condensing unit and is led out to the drain. The drain hose shall hang freely with a gentle bend.
Installation manual
fig.W00184A
fig.W00203A