Table of Contents
Advertisement
using the right Groove, hold the workpiece firmly against the Miter Gauge with your
right hand and grip the Handle with your left hand.
6.
Make sure the workpiece is not touching the Saw Blade (86D).
7.
Plug the Power Cord Plug into the nearest 220 volt, grounded, twist lock, electrical
outlet. Then, turn the Power Switch (17E) to its "on" position.
8.
Allow the Saw Blade (86D) to spin up to full speed before feeding the workpiece
into the Saw Blade with the Miter Gauge.
9.
Make sure to gradually feed the workpiece into the Saw Blade (86D). Do not attempt
to force the Table Saw to cut faster or greater than its capacity.
10.
When the cut is completed, press the Power Switch (17E) to its "off" position.
Then, unplug the Power Cord Plug from its electrical outlet.
Making a rip cut:
warning! Make sure the Clear Blade Guard (2B) is lowered over the Saw Blade
1.
(86D) and is working properly to prevent possible injury.
warning! NEVER stand directly in the line of the cut. Stand to the side of the
2.
Table Saw to reduce the risk of injury.
3.
warning! NEVER push a small piece of wood into the Saw Blade (86D) with
your hand. For small pieces of wood, use a pushstick to move wood into and past
the Saw Blade.
4.
Remove the Miter Gauge (4A) and attach the Rip Fence Bracket Body (9C) over
the Front Guide Rail (3C) and Rear Rail (2C) of the Table Saw.
5.
Place a support (not included) the same height as the Saw Table (8E) behind the
Table Saw for cut workpieces.
6.
Make sure the workpiece is not touching the Saw Blade (86D).
7.
Plug the Power Cord Plug into the nearest 220 volt, grounded, twist lock, electrical
outlet. Then, turn the Power Switch (17E) to its "on" position.
8.
Allow the Saw Blade (86D) to spin up to full speed before feeding the workpiece
into the Saw Blade.
9.
Make sure to gradually feed the workpiece into the Saw Blade (86D). Do not attempt
to force the Table Saw to cut faster or greater than its capacity.
When the cut is completed, press the Power Switch (17E) to its "off" position.
10.
Then, unplug the Power Cord Plug from its electrical outlet.
for technical questions, please call 1-800-444-3353.
SKU 95112
Page 22
Advertisement
Table of Contents
