Features - Mitsubishi Electric JT-SB216JSH2-W-NE Handbook

Request for repair
● Before repairs, take the product off the wall.
● Inspect the earth condition, and repair it if it is incomplete. Make sure that an earth leakage breaker or an over-
load protection device is installed, if it is not installed, recommend the dealer to install one.
● Check whether the air filter, side cover, and the drain tank are installed securely in place.
● Do not leave a towel or other object in the hand-drying area.
● Never place any object on the main body nor cover it.
● Make sure that the product is not being used in any of the following locations:
• Outdoors
• Locations where the temperature could be lower than 0ºC
• Locations where the temperature could be higher than 40ºC
• Locations where there is a lot of dust
• Locations where there is a lot of condensation
• Locations where salt damage could occur
• Vehicles (including ships and airplanes)
• Locations where corrosive, neutral, or reductive gases are present
• Near food or tableware
• Kitchens
• Locations where the product may come into direct contact with water (Where there is a risk of water splashing)
• Locations where the product is in direct sunlight or strong light (It may cause sensor malfunction)
• Rooms that have a sterilization basin, swimming pools, or bathrooms
Make sure that the product operates properly upon completion of repair. Clean the product and the surrounding
area, and then notify the customer of the completion of repair.

2. Features

• The silent wave nozzle has reduced operating sound by 2 dB.
• The newly added "High air speed" (for the heater-less type: JT-SB216KSN2-W-NE) has improved the drying
performance.
• Power control section has been removed to prevent misuses.
• Cleanable drain ditch
• Exteriors can be cleaned by wiping with alcohol.
• The square design matches various lavatories.
─ 4 ─