Mitsubishi Electric JT-SB216JSH2-W-NE Handbook page 21

(8) Terminal block (with a thermal fuse)
1 Unscrew the clamping screw, and remove the terminal block.
(One PPT screw 4×30, indicated by )
2 Remove the lead wires from the filter circuit board (JT-30F8).
→ See (6) 1 to 5.
3 Remove the lead wires from the terminal block.
Assembly precaution
When running the lead wire through the groove of the terminal plate,
set the thermal fuse right under the terminal block.
For JT-SB216JSH2-W/H/S-NE
(9) Heater (PTC)
1 Unscrew the side panel (left (L) and right (R)) clamping screws.
(Two PTT screws 4×16, indicated by )
2 Remove the side panel L in the direction of the arrow.
Assembly precautions
• Install the side panel L after installing the PCB cover for the power
circuit board.
• Take care not to pinch the lead wires.
• Fit the side panel L into the groove of the panel (back) and the base.
3 Remove the side panel R in the direction of the arrow.
Assembly precaution
Fit the side panel R into the groove of the panel (back) and the base.
─ 21 ─
Terminal block
Terminal plate Thermal fuse
Side panel L
Panel (back)
Side panel R
Base Panel (back)
Base