Advertisement
2017-08-15 16:55
second phase to measure the output of the PV Inverter. See see the AC Wiring chapter in this manual.
6. Changing the modbus address
1.
Press the joystick down until until the display shows 'Pass'. The joystick on the right side on the
display, above the front selector).
2.
Press the joystick down again and release immediately.
3.
Press the joystick right several times until 'Address' appears. Press the joystick down. Now you can
adjust the address by pressing the joystick up and down. Set it to 2.
4.
Press down again. 'Baudrate' appears.
5.
Press down again twice. 'Address' appears again.
6.
Press right until 'End' appears.
7.
Press down. The display now shows measurements again.
Note that only one extra Energy meter can be added: the systems works only with address 1 (the
default) and 2.
DISQUS
View the discussion thread.
From:
https://www.victronenergy.com/live/
Permanent link:
https://www.victronenergy.com/live/energy-meters:em24
Last update: 2017-07-19 14:55
Victron Energy - https://www.victronenergy.com/live/
7/7
- Victron Energy
Energy Meter EM24 manual
Advertisement
