2017-08-15 16:55
On the CCGX go to the grid meter in the Wired AC sensor settings. Make sure 'Phase type' is set to
'Single phase' and 'PV inverter on phase 2' is enabled.
Front selector
Change the front selector so it is not in the locked state. This will allow it to be automatically
configured by the rest of the system the meter. The front selector is located next to the display as
indicated in this image:
3. Connection to CCGX
Option A: wireless Zigbee connection
Step 1.
Connect the Zigbee to USB converter to the CCGX using the supplied USB cable. A few seconds after
connecting, the active LED should be on and the TX/RX LED should be blinking (the converter takes its
Victron Energy - https://www.victronenergy.com/live/
3/7
Energy Meter EM24 manual