Speed Dial Pause And Flash/Recall Storage - Toshiba Strata CT System Administrator Manual

Setting System Parameters
Table 4 Feature Access Codes (continued)
4
Pickup any ringing Exchange line (new call only)
Pickup Station Page or Ringing Door Phone
4
Pickup External Page
Pickup Line on Hold (lines 1~99)
Pickup Line on Hold (lines 100~200)
1. These codes can be used during an Exchange line call.
2. Background music speakers can only be turned ON/OFF from the Administrator's telephone.
3. XXX = Auto Park Orbit 9 9 9 (access the next available park orbit), or General Park Zones 900~919, or [PDN] on which the
call should be parked. Only use 999 with LCD telephones.
4. This feature will hold an existing call when the button is pressed. If the button is pressed when not on a call, pickup or page
will still be accessed. These codes can be used during an Exchange line call.
H
5. After pressing the feature button, the user dials the line number (01~99) to pickup the line.
6. After pressing the feature number, the user dials the line number (100~200) to pickup the line.

Speed Dial Pause and Flash/Recall Storage

C
Some Speed Dial numbers may require a pause (long or regular) or hookflash be included (e.g., tone
delay requires a pause at the beginning of a Speed Dial number).
The Flash button stores a flash signal
only if Spd Dial Pause is programmed
as a flexible button on the telephone. The
flash signal is 0.5 or 2 seconds long (set
in system programming) and is displayed
on the LCD as "F-".
Press Flash
...or enter the hookflash dial code (Cnf/
Trn + #45).
Strata CT System Administrator Guide October 2000
Features
5
6
Hookflash
Hold + [PDN] + #59
Hold + [PDN] + #5#30
4
Hold + [PDN] + #5#35
[PDN] + #5 + #70 (01~99)
[PDN] + #5 + #7 (100~200)
Regular Pause
The pause is either 1.5 or 3 seconds
(set in system programming). The
LCD displays "P-".
Press Spd Dial Pause
...or if Spd Dial Pause is not on the
telephone, press Flash to store a
pause.
Speed Dial—Advanced Features
Feature Access Code Sequence
Long Pause
Ten-second pause, which can be
entered anywhere in the Speed Dial
number. The LCD displays "L-".
Press Spd Dial Lng Pause.
21