Displaying Vsan Trunking Information; Default Settings For Vsan Trunks - Cisco Nexus 6000 Series Configuration Manual

Displaying VSAN Trunking Information

Step 4
Step 5
Step 6
Displaying VSAN Trunking Information
The show interface command is invoked from the EXEC mode and displays VSAN trunking configurations
for a TE port. Without any arguments, this command displays the information for all of the configured interfaces
in the switch.
The following example shows how to display the trunk mode of a Fibre Channel interface:
switch# show interface vfc33
vfc33 is up
...
The following example shows how to display the trunk protocol of a Fibre Channel interface:
switch# show trunk protocol
Trunk protocol is enabled
The following example shows how to display the VSAN information for all trunk interfaces:
switch# show interface trunk vsan 1-1000
vfc31 is not trunking
...
vfc311 is trunking
...
san-port-channel 6 is trunking

Default Settings for VSAN Trunks

The following table lists the default settings for VSAN trunking parameters.
Cisco Nexus 6000 Series NX-OS SAN Switching Configuration Guide, Release 6.x
62
Command or Action
switchport trunk allowed vsan add vsan-id
Example:
switch(config-if)# switchport trunk allowed
vsan add 40
no switchport trunk allowed vsan vsan-id - vsan-id
Example:
switch(config-if)# no switchport trunk allowed
vsan 61-65
no switchport trunk allowed vsan add vsan-id
Example:
switch(config-if)# no switchport trunk allowed
vsan add 40
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN)
Port WWN is 20:83:00:0d:ec:6d:78:40
Peer port WWN is 20:0c:00:0d:ec:0d:d0:00
Admin port mode is auto, trunk mode is on
Belongs to san-port-channel 6
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Configuring VSAN Trunking
Purpose
Expands the specified VSAN to the
new allowed list.
Deletes the specified VSAN range.
Deletes the expanded allowed list.
OL-27932-01