Tracking Multiple Ports; Monitoring Ports In A Vsan - Cisco Nexus 6000 Series Configuration Manual

Configuring Port Tracking
In the following figure, only if both ISLs 2 and 3 fail, will the direct link 1 be brought down. Direct link 1
will not be brought down if either 2 or 3 are still functioning as desired.
Figure 34: Traffic Recovery Using Port Tracking

Tracking Multiple Ports

To track multiple ports, perform this task:
Procedure
Step 1
Step 2
Step 3

Monitoring Ports in a VSAN

You can optionally configure one VSAN from the set of all operational VSANs on the tracked port with the
linked port by specifying the required VSAN. This level of flexibility provides higher granularity in tracked
ports. In some cases, when a tracked port is a TE port, the set of operational VSANs on the port can change
dynamically without bringing down the operational state of the port. In such cases, the port VSAN of the
linked port can be monitored on the set of operational VSANs on the tracked port.
If you configure this feature, the linked port is up only when the VSAN is up on the tracked port.
The specified VSAN does not have to be the same as the port VSAN of the linked port.
OL-27932-01
Command or Action
switch# configure terminal
switch(config)# interface vfc vfc-id
switch(config-if)# port-track interface
interface vfc vfc-id | san-port-channel
port
Cisco Nexus 6000 Series NX-OS SAN Switching Configuration Guide, Release 6.x
Configuring Port Tracking
Purpose
Enters global configuration mode.
Configures the specified interface and enters the
interface configuration mode. You can now configure
tracked ports.
Tracks the linked port with the specified interface.
When the tracked port goes down, the linked port is
also brought down.
187