Creating Zone Sets And Adding Member Zones - Cisco Nexus 6000 Series Configuration Manual

Zone Sets
Local sWWN interface
Domain ID interface
Remote sWWN interface
pWWN
The following example shows how to configure different types of member alias:
switch(config)# fcalias name AliasSample vsan 3
pWWN example:
switch(config-fcalias)# member pwwn 10:00:00:23:45:67:89:ab
fWWN example:
switch(config-fcalias)# member fwwn 10:01:10:01:10:ab:cd:ef
FC ID example:
switch(config-fcalias)# member fcid 0x222222
Domain ID example:
switch(config-fcalias)# member domain-id 2 portnumber 23
Local sWWN interface example:
switch(config-fcalias)# member interface vfc 21
Remote sWWN interface example:
switch(config-fcalias)# member interface vfc 21 swwn 20:00:00:05:30:00:4a:de
Domain ID interface example:
switch(config-fcalias)# member interface vfc21 domain-id 25
Device alias example:
switch(config-fcalias)# member device-alias devName

Creating Zone Sets and Adding Member Zones

You can create a zone set to include several zones.
Procedure
Step 1
Cisco Nexus 6000 Series NX-OS SAN Switching Configuration Guide, Release 6.x
90
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
Configuring and Managing Zones
member interface type slot/port
If this is a 10G breakout port, the slot/port
Note
syntax is QSFP-module/port.
member interface type slot/port domain-id
domain-id
If this is a 10G breakout port, the slot/port
Note
syntax is QSFP-module/port.
member interface type slot/port swwn swwn-id
If this is a 10G breakout port, the slot/port
Note
syntax is QSFP-module/port.
member pwwn pwwn-id
Purpose
Enters global configuration mode.
OL-27932-01