Advertisement
off to suction and discharge ports of recovery
machine. (For best performance use 3/8"
hoses.)
6. Purge all hoses of non-condensables before
recovering refrigerant into recovery cylinder.
7. Open the liquid valve on the recovery tank.
8. Turn the RecoverXL on.
9. Turn the selector VALVE on the RecoverXL to
VAPOR RECOVERY position.
10. Slowly open the valves on your manifold and
use them to regulate the refrigerant pressure to
80 psi maximum.
11. The RecoverXL will recover the vapor
refrigerant. When the suction gauge indicates
Liquid or Vapor Recovery Diagram
RecoverXLT Operating Guide
Direct Liquid/Vapor Recovery
The RecoverXLT is used to pull liquid or vapor
refrigerant directly out of the system and transfer it
into a recovery cylinder.
Liquid recovery is accomplished by connecting to
the high pressure system discharge service port
(Liquid Port) side of the system being serviced.
Vapor recovery can be done by connecting to the
system suction service port (low pressure) side of
the system.
Because the RecoverXLT is capable of recovering
4
the appropriate vacuum, turn the selector valve
OFF.
12. Turn selector valve to PURGE position.
13. When the suction gauge again indicates the
appropriate vacuum the recovery and purge
cycles are complete. Turn the selector valve to
OFF and turn the RecoverXL off.
Note: If the machine is not recovering, refer to
the troubleshooting guide on page 9.
Restart procedures are on the side of the
machine and on page 5.
direct liquid, it is best to first recover all of the
liquid, followed by the vapor. This will make your
job easier and faster. Refer to the following
instructions and the above diagram:
1. Know the type and quantity of refrigerant present
before servicing any system.
2. Turn off power to the system being serviced.
Turn the selector knob to off.
3. Connect your manifold to the system being
serviced. High Side to liquid port and Low Side
Advertisement
