Advertisement
Table of Contents
General Safety Instructions
RecoverXL Operation Guide
Direct Liquid/Vapor Recovery
RecoverXLT Operating Guide
Direct Liquid/Vapor Recovery
Restart Procedure
Push-Pull Liquid Recovery
Recovering R-410A High Pressure Gas
Care and Maintenance - Auto Purge Instructions
Recovery Tips & Techniques
Component Location and List
Troubleshooting Guide
Technical Data
Suction Filter
RecoverXL/XLT Wiring Diagrams
Important Notice to Purchaser
Warranty Information
General Safety Instructions
1) Know your equipment. Read and understand the
operation manual and the labels affixed to this
unit. Learn the applications and limitations, as
well as the specific potential hazards of the
RecoverXL/XLT.
2) Use the correct hoses. Use only hoses designed
for handling of refrigerants. The hose should be
the minimum length required for each job and
equipped with a shut-off device (such as the
compact ball valve) at the end to reduce the
likelihood of refrigerant leaks to the atmosphere.
For best performance we recommend using 3/8"
hoses. YELLOW JACKET hoses are made for
almost every type of refrigerant. See your local
distributor for more information.
3) Ground all equipment. Plug the RecoverXL/
XLT into a properly grounded receptacle using
the appropriate plug.
4) If the detachable power cord is damaged, it
must be replaced by a cord assembly available
from the manufacturer or distributor where
purchased.
5) If the attached power socket is damaged, it
must be replaced by the manufacturer or its
authorized service center in order to avoid hazard.
6) Do not pressure test with compressed air. Some
mixtures of air and refrigerant have been shown to
be combustible at elevated pressures.
7) Avoid dangerous environments. To keep
2
operator exposure to a minimum, use the
RecoverXL/XLT only in areas with sufficient
ventilation.
Recovery should always be performed in well
ventilated areas. Use the RecoverXL/XLT only in
locations where mechanical ventilation which
provides at least four air changes per hour is
present, or place the unit 18" above the floor
during use.
The RecoverXL/XLT should not be used near
open containers of gasoline or any other
flammable liquid. Do not allow refrigerants to
come in contact with open flame. Refrigerant
decomposition in flame results in phosgene gas.
Breathing phosgene gas can be fatal.
8)
Always wear safety goggles and gloves.
Personal protective equipment should be worn to
protect operator from frostbite.
9)
Use caution when connecting or disconnect-
ing. Improper usage may result in refrigerant
burns (frostbite). If a major leak occurs, proceed
immediately to a well ventilated area.
10) Disconnect recovery machine from power
before servicing. An electrical shock hazard is
present when the unit is disassembled.
11) Repair damaged parts. Do not operate the
RecoverXL/XLT if there is a defective part.
Repair the unit to proper operating conditions
before further use.
Page
2-3
3-4
4-5
5
5
6
7
7
8-9
9
10
10
11
12
12
Advertisement
