Connecting The Microphone - Uniden UH9050 Owner's Manual

Connecting the Microphone

Front MIC Jack
Remove the MIC cover using a flat blade screwdriver. Push the MIC plug at the end of
the microphone into the MIC jack until the connection locks into place. Gently tug the
MIC cord to test that the connection is locked. Use the Front MIC Jack threaded rubber
collar to seal the MIC jack entry from dust.
Disconnecting the MIC from the Front MIC Jack
Pull away the threaded rubber collar and move it down along the cord. Using the flat
blade of a screwdriver or similar object carefully press the lock tab at the bottom of the
MIC plug and push it upwards. At the same time tug on the MIC cord to draw back the
MIC plug.
Rear MIC Jack
Use the Rear MIC Jack if the main base is mounted where a front MIC connection is
intrusive or if you wish to use the Remote LCD Speaker MIC with an optional extension
cable.
Peel the dust cover from the rear MIC jack. Push the MIC plug at the end of the
microphone into the MIC jack until the connection locks into place. An optional 2m
extension cable kit is available to enable mounting the main base in a hidden location.
The unit will not function if connected to two Remote LCD Microphones
(optional RM-980) at the same time.
NOTE
UNIDEN UH9050
15
UHF CB Transceiver