AEG AS-IC01-4000 Installation Instructions Manual page 32

31
Setting item
Setup Date/Time
Language
Select Country
Setup mode
User period
PD201709 AEG GRID-TIED THREE-PHASE SOLAR INVERTER (4-10 kW) V.1-17 EN
LCD display
S e t u p D a t e / T i m e
D a t e : 2 0 1 2 / 0 1 / 1 5 1
T i m e : 1 2 : 1 4 : 3 0
Curr. Language : English
English Dutch
Chinese
German
Country : Australia
Germany Greece
England Denmark
Australia Holland
S e t u p M o d e l : I n d e p e n d
I n d e p e n d
P a r a l l e l
U s e r P e r i o d
S t a r t : 2 0 1 2 - 0 1 - 0 1 1
E n d : 2 0 1 2 - 0 2 - 0 1
Instruction
Access the interface and edit the date and time through
" " or " ". Then press "ENT" again to edit the next line.
After editing the four digits, press "ENT" to save and press
"ESC" to exit.
Access the interface and edit the language through " " or
" ". Then press "ENT" again to save the edition and press
"ESC" to exit. The default language is English.
Access the interface and select country through " " or
" ". And then press "ENT" again to save the edition and
press "ESC" to exit.
The DC input mode includes "independent" and "parallel":
"independent mode" is the independent MPPT of Track A
and Track B; "parallel mode" is the parallel MPPT of Track A
and Track B. The default mode is "independent".
The input mode setting is invisible if the inverter is in
power generation mode. It is only available when the DC
power is on and the AC power is turned off
Press " " or " " to select the setting mode and press
"ENT" to save the setting or "ESC" to return.
If the situation of section 5.4.8 occurs, it is necessary to
switch the DC input to "parallel" mode.
Access the interface and edit the user period through " "
or " ", then press "ENT" again to edit the next digit. After
editing, press "ENT" to save and press "ESC" to exit.
Time and date need to be set to a later time / date than the
one of the system setting. The start time needs to be
earlier than the end time. The setting date and time are
used for statistics.
31