Mechanical Parameters - Emerson Liebert PEX Series User Manual

Slope liquid
Outdoor unit
Figure 2-10 shows the arrangement of the cooling water system, which requires the water hotter than 4°C. Use
heaters if the water source in site cannot meet this requirement. The cooling tower should be a closed loop system.

2.3.3 Mechanical Parameters

Indoor unit mechanical parameters
The mechanical parameters of the indoor unit are shown in Figure 2-11, Figure 2-12, Figure 2-13 and Table 2-1.
Sealed
Slope discharge
Figure 2-9 Compressor installed higher than condenser
Closed cooling tower
Exhaust water valve
Figure 2-10 Arrangement of cooling water system
Liebert.PEX2 Series Air Conditioner User Manual
Chapter 2 Mechanical Installation
Indoor unit
Heat insulation floor Floor
Expansion water tank
Manometer
T
Temperature
gauge
Strainer
Liebert.PEX-T unit
Raised floor
Humidifier water in
Condensate drain
Condenser water out
Condensed water out
Supplementary valve
Filter Pump
P
M u nit
Ball
valve
Drain valve
11
supply