Bench And Function Tests; Setting Communication Parameters - ABB CP420B Installation And Operation Manual

6.3

Bench and Function Tests

Set dip switches SW3 and SW4 = OFF to be able to run the bench and function
tests for the CP420. Turn on the operator terminal to display the following
screen:
The bench test performs an overall hardware test, and the function test lets the
user select which item to be tested.
Note:
The bench test will clear the application data of the operator terminal.
6.4

Setting Communication Parameters

There are two ways to configure working parameters; to set parameters in the
operator terminal or in CP400Soft.
To set parameters in the operator terminal, select Confg in the system menu.
Note:
Remember to set dip switch SW5 = ON if parameters are set in the operator
terminal.
To set parameters in CP400Soft, select Application/Workstation Setup. Select
the Connection tab to set communication parameters.
Note:
Remember to set dip switch SW5 = OFF if parameters are set in CP400Soft.
ABB, 1SBC159102M0202
Operation
17