Porter-Cable 4112, 4113, 4114, 4115 Instruction Manual page 9

PREPARING ROUTER
Prepare router the same as for
of cut (B) Fig. 5 to 9 ".
/
16
CLAMPING DRAWER PARTS
Drawer parts are clamped in the same manner as those for
1. Position the 1 " half-blind dovetail templet so that there is
/
4
(see Fig. 14).
2. Position drawer front so the left edge is
3. Locate #3 edge guide against drawer front.
ROUTING DOVETAILS
Route dovetails and check for fit the same as those for
1 " HALF-BLIND DOVETAILS
/
4
The following are required to produce
Available
as
Accessories
1 " half-blind dovetails except install 42054 templet guide, 43639 bit, and adjust depth
/
2
1 " (see Fig. 14) past the left edge of the first templet slot.
/
8
1 " Half-Blind Dovetails
/
4
1 " half-blind dovetails:
/
4
889676 #3 Edge Guides (furnished with Model 4114)
42237 Locknut (furnished with Model 4112)
1
4114 " Half-Blind Dovetail Templet
/
4
5
42054 " Templet Guide
/
16
43639 High Speed Steel,
Fig. 13
1
" half-blind dovetails except for the following:
/
2
9 " from back of templet slots to edge of drawer front
/
32
1
" half-blind dovetails.
/
2
Fig. 14
9
1 " Dovetail Bit
/
4