1/2 Half-Blind Dovetails; Preparing Router; Clamping Drawer Parts - Porter-Cable 4112, 4113, 4114, 4115 Instruction Manual

PREPARING ROUTER

1. DISCONNECT ROUTER FROM POWER SOURCE.
2. Insert templet guide, (A) Fig. 4, in hole (B), in router sub-base (C).
3. Install templet guide locknut (D) on templet guide and firmly tighten to lock templet guide in sub-base.
4. Insert dovetail bit, (A) Fig. 5, through templet guide into router collet.
5. Adjust router so dovetail bit projection (B) from bottom of router sub-base (C), is

CLAMPING DRAWER PARTS

1. Temporarily clamp the left side of the drawer "inside out" under front clamp bar and extending approximately
above top surface of the base as shown in Fig. 6.
1 " HALF-BLIND DOVETAILS
/
2
The following are required to produce
#1
4113
42046
Available 42237 Locknut (furnished with Model 4112)
as
Accessories
43705 Carbide Tipped,
or
43750 Carbide Tipped,
Fig. 4
Fig. 6
1
" half-blind dovetails.
/
2
Edge Guide (furnished with Model 4112)
1 " Half-Blind Dovetail Templet (furnished with Model 4112)
/
2
5 " Templet Guide (furnished with Model 4112)
/
8
1 " Dovetail Bit (
/
2
1 " Dovetail Bit (
/
2
Fig. 3
6
1 " Shank)
/
4
1 " Shank)
/
2
9 ".
/
16
Fig. 5
Fig. 7
1 "
/
4