S
S
UPER
ERVER 2028R-TXR User's Manual
Please note that the option-Both is not supported by the Windows Server 2012/
R2 OS. The options are Both, SATA Controller, and sSATA Controller.
sSATA Port 0~ Port 3
This item displays the information detected on the installed sSATA drives on the
particular sSATA port.
•
Model number of drive and capacity
•
Software Preserve Support
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port specifi ed by the user. The options are
Disabled and Enabled.
sSATA Port 0 ~ Port 3 Hot Plug
Select Enabled to enable hot-plugging support for a port specifi ed by the user,
which will allow the user to replace a SATA disk drive installed on this port without
shutting down the system. The options are Enabled and Disabled.
sSATA Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and Disabled.
Port 0 ~ Port 3 sSATA Device Type
Use this item to specify if the sSATA port specifi ed by the user should be con-
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
Server ME (Management Engine) Confi guration
This feature displays the following system ME confi guration settings.
•
General ME Confi guration
•
Operational Firmware Version
•
Recovery Firmware Version
•
ME Firmware Features
•
ME Firmware Status #1
ME Firmware Status #2
7-22