6: Advanced Settings - Iridium GO! User Manual

6: Advanced Settings

Device Display Menu
The screen displays status messages and icons. There is a configuration menu which is controlled
using the two Panel buttons. The display automatically turns off after a period of inactivity.
The following menu system (navigation by using the right and left buttons):
Tracking
Send Quick GPS
Internet
Start Internet Connection
Power mode
Set Wi-Fi – On (default) / Off
Set GPS – On demand (default) / Always On
Audio
Mute / Restore Audio
Information*
6
Languages
English, French, Japanese, Russian, Spanish
*Information mode displays the Device Serial number, Main Firmware, Wi-Fi SSID, IP Address, IMEI,
ICCID, Transceiver Firmware, and Hardware Revision.
NOTE: Display Menu is subject to change – please check latest firmware
36 Iridium GO! User Manual
Power Modes
Iridium GO! has the following Power Mode settings:
Power Mode... Indicates
Wi-Fi ON (default) The Wi-Fi access point is ON, and will maintain connection to devices, and
push notifications and incoming calls (if Iridium is ON and registered).
Wi-Fi OFF Users cannot connect to Iridium GO! over Wi-Fi. This mode could be
chosen if Iridium GO! is used to extend battery run time for device only
SOS, or device only Tracking.
GPS On demand GPS is on for initial Iridium GO! turn on, and then powers off GPS receiver
(default) to save battery power. GPS will start up automatically when required to
send a Track message, or when SOS emergency is activated. Acquisition
of GPS location may take longer in this mode.
GPS Always On GPS receiver is always running to maintain fastest location information
for use in tracking and SOS messages.
6
Iridium GO! User Manual 37