Iridium GO! User Manual page 17

The SOS can also be activated from the Iridium GO! application by
pressing on the SOS button from the main screen.
You will be prompted to enter an emergency call recipient and
emergency message recipient each time your Iridium GO! is
powered on until these contacts are programmed. From the main
menu, Press 'Settings' and then navigate to the 'SOS' tab.
After sliding SOS mode, there is a 20 second countdown to
allow cancelling a false alarm. Then once the SOS is activated –
a message and/or call will be initiated and your location will
be sent every 5 minutes to your specified emergency recipient.
To modify these settings, select 'Emergency Options. '
4
You must configure the Emergency Mode in order for the SOS to send an emergency message to a designated Call Recipient and
Message Recipient. Failure to configure the SOS button will result in no message being sent when the SOS button is pressed. This
could prevent or delay an emergency response and result in serious injury or death.
Important:
1. Swivel Antenna must be raised for SOS message or SOS call to be made.
2. You must configure the SOS button Emergency Mode contact in order to send an emergency message to a designated
emergency call recipient.
3. SOS Emergency Voice Call is only supported when using SOS via Iridium GO! application.
4. SOS mode will remain activated even if Iridium GO! application or smartphone is turned off.
26 Iridium GO! User Manual
WARNING
Configuring Tracking
Iridium GO! can send location track messages in two ways:
1. Quick GPS – Press 'Track' from Iridium GO!
application main screen, or from Tracking
Message menu of Iridium GO!
Send quick GPS
Send a quick GPS
message now?
Back
Next Select No Yes
Quick GPS from Iridium GO! device
2. Interval Tracking – Messages are sent
automatically according to the interval
tracking frequency.
Sending message...
Back
Track Messaging from
Iridium GO! application
Iridium GO! User Manual
4
27