Hitachi V810 User Manual page 15

ADJUSTMENT (Continue)
Item
Colour Select
Red
simultaneously.
When Green or
Blue is selected,
singly.
Green
simultaneously.
When Blue or
Red is selected,
Colour
Balance
singly.
Blue
simultaneously.
When Green or
Red is selected,
singly.
(This operation is
valid only when
Colour Red,
Reset Blue is selected
already.)
When EasyMenu is not shown, you can start the adjustment of Contrast and
Brightness only, without pressing any select switch.
It is recommended to follow the following procedures for the adjustment of
distortions;
(1)
(2) "Pincushion"
(3) "Right Pincushion" and "Right Trapezoid" (Adjust the right side.)
The mode "No.4:USER" is not factory set, and it is programmable if desired.
After adjustment of "Colour Balance" (Red, Green or Blue) and "STORE" (refer to
page 14), your colour balance will be restored by selecting "No.4:USER".
12
Adjust Switch
Select
Switch
and
is valid
and
is valid
and
is valid
Green or
simultaneously,
for
2 seconds.
and "Trapezoid"
changes the colour to the next mode.
No.1:9300K
No.4:USER (if available)
changes the colour to the previous
mode.
No.4:USER
No.3:5000K
No.1:9300K
makes the Red stronger. When the Red
reaches the upper limit, it makes the
Green and Blue weaker.
makes the Green and Blue stronger.
When the Green or Blue reaches the
upper limit, it makes the Red weaker.
makes the Green stronger. When the
Green reaches the upper limit, it makes
the Blue and Red weaker.
makes the Blue and Red stronger.
When the Blue or Red reaches the
upper limit, it makes the Green weaker.
makes the Blue stronger.
Blue reaches the upper limit, it makes
the Red and Green weaker.
makes the Red and Green stronger.
When the Red or Green reaches the
upper limit, it makes the Blue weaker.
cancels the currently adjusted colour,
and calls the colour condition of the
previously selected colour mode.
about
(Adjust
Function
No.2:6500K
No.3:5000K
(if available)
No.2:6500K
When the
"Rotation"
the left side.)