Operation - Hitachi V810 User Manual

OPERATION

Control Switches
Select Switch
Input Switch
POWER ON/OFF
Press the Power switch, to switch the power ON or OFF.
When power is ON, the power LED lights.
INPUT
This monitor has two input terminals, INPUT 1 and INPUT 2. Therefore, you
may connect two computers simultaneously. When two computers are active,
you may switch the input signal by using the EasyMenu controls.
INPUT SELECT
INPUT 1 is the initial factory default setting. If you
would like to use INPUT 2, proceed to the "EasyMenu"
and select the "INPUT SELECT" mode. Press the " "
key and this will select INPUT 2.
Plug and
and not supported on INPUT 2.
AUTO INPUT SELECT
This monitor has an "INPUT AUTO SELECT" function which will select the input
by scanning for an input signal on either INPUT 1 or INPUT 2.
"ON" : Press the "
When there is no input signal received from the input connection which was selected
by "INPUT SELECT", the "INPUT AUTO SELECT" function will select the alternate
connection. If there is no input signal received from either connection the monitor will
default to the "POWER SAVE" mode.
If there are two computers connected to the monitor and for example you restart one
of the computers or it is activated from the "POWER SAVE" mode, it is possible that
the monitor may change to an undesired input connection. This may be easily correct
by changing the input selection to the desired INPUT 1 or INPUT 2 using the "INPUT
SELECT" function.
"OFF" : Press the "
When the "INPUT AUTO SELECT" function is placed in the "OFF" mode, the monitor
will default back to the selection that has been selected by the "INPUT SELECT"
function, and the input will no longer be selected automatically.
Page 9~13 "ADJUSTMENT"
Play function
" key.
" key.
Adjust Switch
Page 10 "DEGAUSSING"
Page 9 "POWER ON/OFF"
is only supported
Sample of "EasyMenu"
on INPUT 1,
9