Field Settings
3. Field Settings
3.1
Temperature Display Switch
You can select Celsius or Fahrenheit for temperature display.
ARC466A6
Press the TEMP
You can also change the unit of temperature display by pressing the TEMP
3.2
When 2 Units are installed in 1 Room
When 2 indoor units are installed in 1 room, 1 of the 2 indoor units and the corresponding
Outline
wireless remote controller can be set for different addresses.
(1) Remove the battery cover of the remote controller and cut the address jumper.
Procedure
(2) Press the center of the TEMP button and the OFF button on the remote controller at the
(3) Select A (address setting) with the TEMP
(4) Press the FAN button to enter the address setting mode.
(5) Press the indoor unit ON/OFF button while the operation lamp is blinking.
(6) Press the FAN button on the remote controller for 5 seconds to return to the normal mode.
93
and ON TIMER buttons at the same time for 5 seconds to change the unit
of temperature display.
at the same time for 5 seconds.
same time.
→ The indoor unit operation lamp blinks for 1 minute.
(1)
(2) (3)
or TEMP
Jumper
EXIST
CUT
Jumper
(3)
(2)
(4) (6)
(R21822)
and buttons
(R14477)
button.
Address
1
2
(R21071)
(4)
Operation lamp
(5)
Indoor unit ON/OFF
ON/OFF
button
Trial Operation and Field Settings
SiBE041525F
(R22992)